2165 South 1800 East
Gooding, Idaho 83330
208-934-5050
brockman@brockmansrifles.com
Gooding, Idaho 83330
208-934-5050
brockman@brockmansrifles.com
|
||
          |
Generation
III Rear Sight Rear Sight Adjustment for Windage: Using the Allen wrench that was provided for you, loosen the the round-headed screw on either side of the sight, depending on which way you are adjusting the sight. Tighten the round-headed screw on the opposite side of the sight until the aperture is in the correct position. Make sure both screws are "snug" enough to hold the base in place. Make sure that you move your sight in the direction that you want your bullet to go. Rear Sight Adjustment for Elevation: Using the Allen wrench that was provided for you, loosen the set screw on the side of the rear sight. This will allow you to turn the aperture and stem either clockwise, to lowerthe aperture, or counter-clockwise, to raise the aperture. The aperture may be turned 1/2 of a turn if that is all it needs. After adjusting the sight, re-tighten the set screw to a "snug" fit.
|
|
|
|
|